Copyright © 2001-2018 MultiMedia Soft

StreamOutputSpeakerSet method

Previous pageReturn to chapter overviewNext page

Remarks

 

Redirects the output of the given player to a specific speaker of the current output device. The current output speaker can be obtained through the StreamOutputSpeakerGet method.

 

A call to this method will have no effect if the involved player has been added to a custom stream mixer through the StreamMixerPlayerAdd or StreamMixerPlayerAddToSpeaker methods.

 

For further details about speakers assignment, take a look to the How to work with multiple output devices and speakers section.

 

 

Syntax

 

[Visual Basic]

control.StreamOutputSpeakerSet (

nPlayer as Integer,

nSpeaker as enumSpeakers

) as enumErrorCodes


 

[C++]

short control.StreamOutputSpeakerSet (

short nPlayer,

short nSpeaker

);


 

Parameter

Description

 

 

nPlayer

Number representing the zero-based index of the involved player.

nSpeaker

The new speaker assigned to the given player.

Supported values are the following:

Mnemonic value

Numeric value

Meaning

SPEAKER_FRONT

0

Front speakers (Stereo)

SPEAKER_REAR

1

Rear speakers (Stereo)

SPEAKER_CENTER_LFE

2

Center speakers (Stereo)

SPEAKER_REAR_CENTER

3

Rear center speakers (Stereo)

SPEAKER_FRONT_LEFT

4

Front-left speaker (Mono)

SPEAKER_FRONT_RIGHT

5

Front-right speaker (Mono)

SPEAKER_REAR_LEFT

6

Rear-left speaker (Mono)

SPEAKER_REAR_RIGHT

7

Rear-right speaker (Mono)

SPEAKER_CENTER

8

Center speaker (Mono)

SPEAKER_LFE

9

LFE or Subwoofer speaker (Mono)

SPEAKER_REAR_CENTER_LEFT

10

Rear Center Left speaker (Mono)

SPEAKER_REAR_CENTER_RIGHT

11

Rear Center Right speaker (Mono)

 

Below you can see the positioning of the Stereo speakers on a wide 7.1 configuration (the reported blue numbers corresponds to the Numeric value of the parameter)

amp3dj_i00006c

and below you can see the positioning of the Mono speakers on the same wide 7.1 configuration

 

amp3dj_i00006d

 

Return value

 

Value

Meaning

 

 

Negative value

An error occurred (see the LastError property for further error details)

enumErrorCodes.NOERROR (0)

The method call was successful