Copyright © 2008-2018 MultiMedia Soft

MixAutomationItemAddFromRecorder method

Previous pageReturn to chapter overviewNext page

Remarks

 

Adds contents of a recording session belonging to an instance of the Audio Sound Recorder for .NET component to the mixing automation list.

 

For further information about management of append automation sessions refer to the How to mix or append several sounds in one single shot tutorial.

 

 

Syntax

 

[Visual Basic]

Public Function MixAutomationItemAddFromRecorder (

hWndRecorderCtrl as IntPtr,

nStartPosition as Int32,

nEndPosition as Int32,

fVolume as Single,

nMixPosition as Int32

) as enumErrorCodes


 

[C#]

public enumErrorCodes MixAutomationItemAddFromRecorder (

IntPtr hWndRecorderCtrl,

Int32 nStartPosition,

Int32 nEndPosition,

float fVolume,

nMixPosition as Int32

);


 

[C++]

public: enumErrorCodes MixAutomationItemAddFromRecorder (

IntPtr hWndRecorderCtrl,

Int32 nStartPosition,

Int32 nEndPosition,

float fVolume,

nMixPosition as Int32

);


 

 

Parameter

Description

 

 

hWndRecorderCtrl

Window handle to the instance of the Audio Sound Recorder for .NET component.

nStartPosition

Start position, expressed in milliseconds, of the range to load from the added editing session

nEndPosition

End position, expressed in milliseconds, of the range to load from the added editing session

fVolume

Volume level applied to the added song when it will be appended.

Supported values are expressed with a linear volume in the range from 0 to 100. In case you should need to set a volume expressed in dB, before setting this parameter you could convert the value in dB into a linear value through the following formula (C syntax):

VolumeLinear = 100 * pow (10, VolumeInDB/20);

nMixPosition

Position, expressed in milliseconds, inside the destination sound where the added recording session will be mixed

 

 

Return value

 

Value

Meaning

 

 

Negative value

An error occurred. Check the LastError property value in order to see the last error.

enumErrorCodes.ERR_NOERROR (0)

The method call was successful.